utensil washers
LU-130 UTENSIL WASHER
|
RACK DIMENSIONS
|
|
1.350 x 700 mm |
NO. OF RACKS |
|
1 dimension 1350 x 700mm |
MAXIMUM UTENSIL HEIGHT |
|
680 mm |
CYCLE |
|
3-6-9 min. |
OUTPUT RACKS / H |
|
20-10-6 |
DRAIN PUMP |
|
0.37 kW |
ELECTRICAL SUPPLY |
|
415V / 50Hz / 3-N |
ELECTRICAL LOADING |
|
|
Wash pump |
|
2.2 + 2.2 kW |
Wash tank |
|
9.8 kW |
Rinse tank |
|
19.6 kW |
Total power |
|
24 kW |
WATER SUPPLY TEMP. |
|
65ºC |
WASH TEMPERATURE |
|
55ºC - 65ºC |
RINSE TEMPERATURE |
|
82ºC |
WATER CAPACITY |
|
|
| Wash tank |
|
150 L |
| Rinse tank |
|
14 L |
Water supply pressure |
|
2 - 4 bar / 200 - 400 kpa |
WATER USAGE PER CYCLE |
|
14 L |
EXTERNAL DIMENSIONS |
|
|
Width |
|
1520 mm |
Depth (closed/open) |
|
890 / 1235 mm |
Height (open/closed) |
|
1760 / 2080 mm |
NET WEIGHT |
|
220Kg |
. These machines have been designed in accordance with a specification
laid down in European directives 89/392/EEC AND 73/23/EEC
. Please note : as a result of continuous product improvements ,
these specifications are subject to change without prior notice |
| INSTALLATION |
Machines are
to be installed by suitably qualified personnel, and in accordance
with local ordinances, codes and standards, installed on a self
draining floor.
The machine must be level, use the adjustable legs to level the
machine |
| WATER SUPPLY |
Connect the machine to the hot water outlet,
the temperature of the in-coming water must be greater than 60°C |
| WATER PRESSURE |
Not less than 2 bar ( 200 Kpa ) and no greater
than 4 bar ( 400 kPa ) |
| LOW WATER PRESSURE |
A pressure booster pump is required for water
pressure less than 2 bar |
| HARD WATER |
In hard water areas a water softener is recommended
especially for glasswashers |
| POWER |
Check that the voltage of the machine coincides
with the mains voltage,
electrical supply 415V / 50 Hz / 3N- |
| COMMISSIONING |
Install the machine as per instructions, check
the drain plugs are in place. Turn on the water first, depress
the main power switch, close the door. Depress the start button,
the machine will begin to fill, the rinse tank will fill first,
then the wash tank. These procedures may take some minutes to
complete, when the ready light comes on the machine will ready
to operate |
Go back
 |
Head Office:
P.O BOX 331
GALSTON
NSW 2151
Phone: 0407 971 451 Or 02 43886828
Email: info@warewashingaustralia.com.au
All initial mail correspondence to Head Office please
* * * * * * * * *
Regional Office Addresses:
NSW
36 MID DURAL ROAD
GALSTON 2159
SYDNEY
QLD
18 LANENA STREET
MT OMMANEY 4074
BRISBANE
VIC
57 CAPELLA STREET
MOORABBIN
MELBOURNE 3189
|
Sitemap | Links
|