utensil washers
LU-61H UTENSIL WASHER
|
RACK DIMENSIONS
|
|
630 x 550 mm |
NO. OF RACKS |
|
1 |
MAXIMUM UTENSIL HEIGHT |
|
820 mm |
CYCLE |
|
2-4-8 min |
OUTPUT RACKS / H |
|
30-15-10 |
DRAIN PUMP |
|
0.37 kW |
ELECTRICAL SUPPLY |
|
400V / 50Hz / 3-N |
ELECTRICAL LOADING |
|
|
Wash pump |
|
3 kW |
Wash tank |
|
5.3 kW |
Rinse tank |
|
8.3 kW |
Total power |
|
11.20 kW |
WATER SUPPLY TEMP. |
|
10-60°C |
WASH TEMPERATURE |
|
10-60°C |
RINSE TEMPERATURE |
|
10-90°C |
WATER CAPACITY |
|
|
| Wash tank |
|
60 L |
| Rinse tank |
|
8 L |
Water supply pressure |
|
2 -4 / 200 -400 |
WATER USAGE PER CYCLE |
|
7 L |
EXTERNAL DIMENSIONS |
|
|
Width |
|
675 |
Depth (closed/open) |
|
803 / 1.150 |
Height (open/closed) |
|
2.015 / 2.200 |
NET WEIGHT |
|
150 Kg |
. These machines have been designed and manufactured in accordance
with the specifications laid down in European directives 89 / 392
/ EEC and 73 / 23 / EEC
. Please note : as a result of continuous product improvements ,
these specifications are subject to change without prior notice
|
| INSTALLATION |
Machines to be installed by suitably qualified personnel
and in accordance with local ordinances , codes and standards,
install the machines on a self draining floor.
The machine must be installed in a level position , use the adjustable
legs to level the machine
|
| WATER SUPPLY |
Connect the machine to the hot water outlet , in coming water
to be greater than 60°C and lesser than 70°C |
| WATER PRESSURE |
Being supplied to the machine is not less than ( 200 Kpa ) and
no greater than 4 bar ( 400 kPa ) |
| LOW WATER PRESSURE |
A booster pump is required for low water pressure to the machine
|
| HARD WATER |
In hard water areas a water softener is recommended especially
for glasswashers |
| POWER |
Check that the voltage of the machine coincides with the mains
voltage , electrical supply 240 / 50Hz / 1 - 400 / 50Hz / 3N - |
| COMMISSIONING |
Enshore that the machine has been installed as per instructions,
and that the drain plugs are in place. Turn on the water first ,
then then switch on the main power switch , close the door , engage
the start button on the machine , the machine will begin to fill
, the rinse tank will fill first , then the wash tank, these procedures
may take some minutes to complete , when the ready light comes on
the machine will ready to operate |
Go back
 |
Head Office:
P.O BOX 331
GALSTON
NSW 2151
Phone: 0407 971 451 Or 02 43886828
Email: info@warewashingaustralia.com.au
All initial mail correspondence to Head Office please
* * * * * * * * *
Regional Office Addresses:
NSW
36 MID DURAL ROAD
GALSTON 2159
SYDNEY
QLD
18 LANENA STREET
MT OMMANEY 4074
BRISBANE
VIC
57 CAPELLA STREET
MOORABBIN
MELBOURNE 3189
|
Sitemap | Links
|